Manual Method 1: Two-Point Shaft Tension
The standard starting technique for tight circumcisions: one anchoring grip near the glans, the other hand drawing shaft skin toward the body.
Who it suits
Method 1 is the classic first technique. It requires no slack skin at all, which makes it the usual recommendation for tight starts (CI-1/CI-2), and it doubles as a precision tool later for targeting a side that is growing more slowly. It is performed flaccid.
The grip
Make an OK-sign with one hand — thumb and index finger forming a ring — and grip the skin just behind the glans. This hand is the anchor; it does not pull. Place the fingertips of the other hand flat on the shaft skin closer to the body, then draw them toward the abdomen. The skin between the two hands comes under tension.
The work
Apply tension until the slack is taken up and the skin feels taut, then ease on just a little more. Hold for 5–30 seconds, relax for a few seconds, and repeat. A session can be as short as a minute or run up to twenty; the trade-off is fixed: more tension is only for shorter holds, and longer sessions need lighter tension.
Because the pressing hand chooses where tension lands, you can bias growth: work the top (dorsal), the underside (ventral), or either side independently — useful when coverage develops unevenly, which it usually does.
Cautions
Tugging should never hurt. Mild redness and warmth afterwards are normal — that is increased blood flow. Pain, soreness that lingers, or skin that feels hot rather than warm means you have overdone it: stop, rest, and come back lighter.
This technique was documented and refined over many years by the RestoringForeskin.org community (2009–2026). This guide is AntiCirc’s own write-up of the method, published as that community’s public home went offline — see the sources below.